|
I've never tried this on photo-etch but it has worked for me on thin brass pieces.
Place the metal part on a rubber block type eraser and roll a piece of 3/16 diameter or so piano wire over it while pressing down.
You only get a few tries at this because brass work hardens very quickly and you have to be careful to keep the wire square with the metal part or it wraps off axis and will be difficult to square up.
__________________
First rule of ground school; This is the ground, don't hit it going fast.
You start flying with a full bag of luck and an empty bag for experience. The object is to fill the bag of experience before you empty the bag of luck.
|