The Aerodrome Forum - View Single Post - DR-1 (Sands): Builders Group

worldcrusier · 19 August 2004, 01:26 PM

I rough cut the rib webs then used a pattern and a table router to finish. The stack of rib pieces was very uniform and only took a few hours to do all the rib webs. Be sure and trial fit the first pieces of each rib. any problems can be corrected before you mass produce all the pieces.

19 August 2004, 01:26 PM	#26 (permalink)
worldcrusier Two-seater Pilot Join Date: Jan 2003 Location: Tulsa, Oklahoma Posts: 206	I rough cut the rib webs then used a pattern and a table router to finish. The stack of rib pieces was very uniform and only took a few hours to do all the rib webs. Be sure and trial fit the first pieces of each rib. any problems can be corrected before you mass produce all the pieces.