The Aerodrome Forum - View Single Post - DR-1 (Sands): Builders Group

Rex · 23 August 2004, 07:26 PM

I set the lathe at 45 rpm and the tool bit holder unit to move at its fastest speed. The tool bit holder did not move fast enough so I would have to move it by hand every once in a while.

This picture shows the rod through the tool holder into the chuck.

23 August 2004, 07:26 PM	#58 (permalink)
Rex Observer Join Date: May 2004 Location: Greenville IL Posts: 31	I set the lathe at 45 rpm and the tool bit holder unit to move at its fastest speed. The tool bit holder did not move fast enough so I would have to move it by hand every once in a while. This picture shows the rod through the tool holder into the chuck.