|
Jenny diorama cont....
I have revised my plans again.Instead of installing the clips I decided that I should clean up all the hanging fuselage brace wires.But before I can do that I must install the tail skid assembly Fig.6-1.No problems here as long as you install it as a complete assembly.The fuselage brace wires top and bottom as well as the internal brace wires were now installed .Here I diverged a bit from the booklet instructions ,as I am using real wire, as opposed to the kit supplied cord.At the opposite end of the wire from the turnbuckle, I drill a small hole thru the longeron and run the wire through ,pull it taunt and glue with a small drop of superglue.When dry, I snip it off close the the longeron and cover the glue spot and wire end with the copper clip.(when I send in the next set of pics I will show this arrangement.) to be cont....
|