Today I finally finished the airshow towcar.Now I have to decide whats next.
Now that I have the Canuck and towcar temporarely positoned in the diorama,space is starting to become a consideration.Where do I put the 2nd Jenny?I think that I will put it on its gear in the tail down position with the center section only installed.The 2nd set of wings will probably be put in wing racks along with the tail planes.I want the wings and tail planes to be in such a position that you can readily tell that they belong to a JN4D.
The workshop takes up a lot of room but I think that is where I will put the 2nd OX5 engine being worked on.THere will be workbenches and a heating stove to build.I plan to have a glowing fire in the stove (as it is armistic day here in Canada & can be cold by November 11.)I want to light the workshop so that the lights can be left on or off .There should be lots of nice effects with the workshop lights shining onto the hangar floor.
If there is room I would like to have a billboard on wheels being towed by an old Harley.Then there is where to put the 5-7 figures? Another consideration is , I was going to cover the fuse but I think that other than a few tattered remnants, I will have to leave it bare ,otherwise the 2nd fuse will block the view to the rear of the hangar and make things look too crowded.The wings on the other hand will be stored up against a sidewall and can be covered and not obstruct the view.
to be cont.....
