[gipsymoth236k]

Dan-San,

A good idea to start this topic, thanks!

Attached is Knowlton's original Albatros-built Fokker D.VII wheel fairing (no fabric covering). Note this Albatros style fairing's 'open-end' variation for easier access to the bungee suspension, as well as the leading edge hinges (look VERY closely at the attached photos). Also note two rolled and seam-riveted 70mm aluminum tubes that are peened over on the ends per typical manufacturing practice. Both tubes run span-wize through this fairing.

One of my longest questions has been - did all D.VII wheel fairings contain these two aluminum tubes, or not? I see they were indeed installed here, and on virtually ALL Fokker Dr.I and E.V/D.VIII wheel fairings. If so, can we please see photos to support other D.VII (specifically) fairings with these two aluminum tubes installed? Anyone?

Thanks, Gary Sewall