The Aerodrome Forum - View Single Post

JohnFitz · 26 June 2008, 07:12 PM

J, make a small flat spot with a Dremel and cutting disc. Just drag the disc lightly across the axle where you will drill the hole. This makes it easier to keep the bit from walking. I am guessing you will slide a piece of brass tubing over it.

26 June 2008, 07:12 PM	#6 (permalink)
JohnFitz Forum Ace Join Date: Mar 2002 Posts: 855	Dr1 J, make a small flat spot with a Dremel and cutting disc. Just drag the disc lightly across the axle where you will drill the hole. This makes it easier to keep the bit from walking. I am guessing you will slide a piece of brass tubing over it.