The Aerodrome Forum - View Single Post

JohnFitz · 27 June 2008, 04:08 AM

J, this is what you want to end up with I think. Brass tube is slid over axle and hole drilled through both. Cotter pin holds washer and wheel in place. In my case the axle is a solid alum. rod so I CA'd the brass tube on but it fit really tight so it's not going anywhere.

27 June 2008, 04:08 AM	#8 (permalink)
JohnFitz Forum Ace Join Date: Mar 2002 Posts: 855	DR1 axle J, this is what you want to end up with I think. Brass tube is slid over axle and hole drilled through both. Cotter pin holds washer and wheel in place. In my case the axle is a solid alum. rod so I CA'd the brass tube on but it fit really tight so it's not going anywhere. Last edited by JohnFitz; 26 September 2008 at 06:00 PM.