Quote:
Originally Posted by Butch
Joe,
It was supposed to be funny. I thought it would be 'fighter squadron' humour, Sid (Machinbird) called it 'ready room' humour, and The Bald Eagle wanted to pile on with something else, something really bad. Take a joke that is made at your expense as a compliment. That is how it was meant. We used to say that negative slack tends to increase. So it did not pay to show thin skin. Just wait until you have the upper hand and then pile on. But in good, malicious humor.
By the way, can you model a SPAD 7 for me? I cannot seem to get anything done on my project since Spadmaker was banished, and since we had our third baby. Baby jokes anyone?
Pete
|
Pete,
"Ready room humour", perhaps so, I took it as a 50/50 chance it was a typical forum attack and responded that way. My stupidity then for letting it get to me.
I will tell you this, the local mid-air shook me up! Reason is because I have seen too many rivets up close myself. Too much density down low around here. So you hit a soft spot, but I figure it maybe was bad timing and not so much a thin skin issue.
My CAD modeling is slow going as it's not my area of expertise. I learned it specifically for a retirement project like this. As it is right now, I can't commit to taking on anything extra since I barely can get my own stuff done. If that should ever change, I will let you know.
All is good then, my apologies for turning sour!