The Aerodrome Forum - View Single Post

RAF56_Ball · 16 April 2009, 08:58 PM

Engine is a Rotec R-2800. It is on the way from Australia.
Been at owrk most of this week, but will be back at the Airport tomorrow and this weekend. Did get tires mounted. Smelled like a french whare house (oh, did I drop an 'o'?) as the only talc I could find was scented.

Hope to do the stab and landing gear cables tomorrow, then will get after the wing center section. Could ahve the wing basic panels done by the end of the week. Will need to make the rib bending jig this week.

16 April 2009, 08:58 PM	#5 (permalink)
RAF56_Ball Forum Ace Contributor Join Date: Jun 2005 Location: Wausau, WI Posts: 742	Engine is a Rotec R-2800. It is on the way from Australia. Been at owrk most of this week, but will be back at the Airport tomorrow and this weekend. Did get tires mounted. Smelled like a french whare house (oh, did I drop an 'o'?) as the only talc I could find was scented. Hope to do the stab and landing gear cables tomorrow, then will get after the wing center section. Could ahve the wing basic panels done by the end of the week. Will need to make the rib bending jig this week. __________________ Glenn 'Chip' Burt Integrity is doing the right thing, regardless. in Honor of Albert Ball. A valiant pilot, but a man of God first and last.