Howdy all,
I've been going on this project for a couple of months now. I'd had a great spurt of working on it while my fiancé was recovering from a motorcycle accident. As I was faster at working on it than gett the images processed, I'll post a few a day till I get caught up...
Here's an overhead of the front cabane mounting block. The engine mount plate is visible below.
Weird that I didn't get images of the frame-up of the fuse. But this one shows the stringer after being fitted to compensate for the line of it going through the front cabane block.
I guess I'm just an old style modeler, I just couldn't see doing the tail cone out of foam. Since I decided to sheet with birch ply, I figured this would give me a better surface to glue to.
Bottom of the cone stringers were cut away to mount the satbilizer. This became a nonissue after the stab broke in the middle while working on the sheeting.
That did give me an idea though...
