Right! Forgot that a convention I was going to was last weekend so I forgot to get these next two up before I went. This is where the ply was at after pulling off the tape.
There was some relaxing that happened afterward but it got enough in the ballpark that it was fairly easy to glue them down.
The end result was this (with dry fitted stab)....
I had to pull the third panel as, after gluing it, I found that the the keel curves up in the middle of the lower wings. I'll have to make two pieces to cover as it would either pop up at one end or the other or oil can in the middle.
Overall I'm pretty happy with how it's gone so far. Lots of hand fitting is still in my future as is buying a couple more pieces of ply.
-Jim