The Aerodrome Forum - View Single Post - Sopwith 1 1/2 Strutter (1/72, Toko)

PrzemoL · 11 August 2009, 02:09 PM

Thank you, Scimitar.

And some steps forward. Cabane struts done by Toko as two "W"s did not fit at all. I had to cut off the extreme legs and shorten all of them by about 1 mm. Then followed the rigging, I only need to pass the aileron controls over the upper wing but this will be done only after its top surface is painted. The holes in the upper wing are already filled with liquid CA glue and should be ready to sand and polish tomorrow.

11 August 2009, 02:09 PM	#44 (permalink)
PrzemoL Forum Ace Join Date: Jun 2007 Location: Poznan, Poland Posts: 811	Thank you, Scimitar. And some steps forward. Cabane struts done by Toko as two "W"s did not fit at all. I had to cut off the extreme legs and shorten all of them by about 1 mm. Then followed the rigging, I only need to pass the aileron controls over the upper wing but this will be done only after its top surface is painted. The holes in the upper wing are already filled with liquid CA glue and should be ready to sand and polish tomorrow. __________________ Ash nazg durbatuluk, ash nazg gimbatul, Ash nazg thrakatuluk, agh burzum-ishi krimpatul.