The Aerodrome Forum - View Single Post - WNW Junkers

beeza · 7 November 2009, 11:30 AM

Hi Hans

thanks for your kind words.

The decals go on easy as long as the surface is a very high gloss and I used Mr. Mark Setter as a decal setting solution, I presume other brands would do the same job.

The holes in the engine door supports where done using a combination of 0.2mm - 0.3mm and 0.4mm drill bits. It was a little fiddly but with care it can be achieved very easily. For the bracing on the doors I used 0.4mm brass tube.

Hope this answers your question - happy modelling.

Des.

7 November 2009, 11:30 AM	#44 (permalink)
beeza Forum Ace Join Date: Jul 2009 Posts: 548	Hi Hans thanks for your kind words. The decals go on easy as long as the surface is a very high gloss and I used Mr. Mark Setter as a decal setting solution, I presume other brands would do the same job. The holes in the engine door supports where done using a combination of 0.2mm - 0.3mm and 0.4mm drill bits. It was a little fiddly but with care it can be achieved very easily. For the bracing on the doors I used 0.4mm brass tube. Hope this answers your question - happy modelling. Des.