DR.I Rigging Diagram

[sixman]

What is a good source for a diagram of the rigging for the Fokker DR.I. I have been able to figure the tailplane, but the bracing over the cockpit and the lines for the ailerons still need to be determined.

[Fokker Ace]

If you have an Eduard 1/48 the marks should be both on the upper wing and top of fuse where the cables went.

If not the Datafiles have the info.

[Dan_San_Abbott]

Hi Sixman:
There are only eight places to rig:
1. Left and right aileron control wires from the upper wing to the fuselage.
2. Left and right aileron control wires from the top and bottom control horns.
3. left and right elevator control wire from the top and bottom horns to the fuselage sides.
4. Rudder control wires from the from the right and left control horns to the sides of the fuselage.
5. Wire cross bracing between the top of the cabane struts to the top of the
fuselage, behind the from cabane struts sockets.
6. The wire cross bracing from the bottom of the fuselage behind the front landing gear leg sockets to the center bottom of the front landing gear legs.
Blue skies,
Dan-San

[sixman]

Dan-San

Thank you for the assistance.